mogu li stavit na svoju plocu DDR400 modul iako u manualu od maticne pise da podrzava DDR266 i DDR333??
ovako to stoji u manualu od m. ploce:
Supported memory
configuration are:
— DDR333: to run DDR333 memory at full speed requires an Intel
Pentium 4 processor with 533 MHz front side bus frequency (FSB)
— DDR333 memory will run only at DDR266 speeds when using a
processor with 400 MHz FSB
— DDR266: requires an Intel Pentium 4 processor with
533/400 MHz FSB, or Intel Celeron processor with 400 MHz FSB
• Unbuffered and non-registered single or double-sided DIMMs
• Serial Presence Detect (SPD) memory only
• Non-ECC RAM (ECC memory will run in non-ECC mode)