Ako je kao kod epsona, onda bi moglo ovako:
ESC p
EXECUTING COMMAND
[Name] Generate pulse
[Format] ASCII ESC p m t1 t2
Hex 1B 70 m t1 t2
Decimal 27 112 m t1 t2
[Range]
m = 0, 1, 48, 49
0 ≤ t1 ≤ 255
0 ≤ t2 ≤ 255
[Default] None
[Printers not featuring this command] None
[Description] Outputs the pulse specified by t1 and t2 to the specified connector pin m as follows:
t1 specifies ON time to ( t1 × 2 ms).
t2 specifies OFF time to ( t2 × 2 ms).
[Notes] Specify a value so that the OFF time is longer than the ON time ( t1 < t2).
[Model-dependent variations] None
m: Connector pin
0, 48 Drawer kick-out connector pin 2
1, 49 Drawer kick-out connector pin 5
Program Example for all printers
PRINT #1, CHR$(&H1B);"p";CHR$(0);CHR$(25);CHR$(250);
A pogledaj i na
http://www.crs-usa.com pa negde pronadji Samsung, ima nekih firmware apdejta, drajvera i slicnih zezalica.