Dobro si rekao "spliteri i OVO" , jer to nije spliter ili ako jeste onda je najgore moguce vrste.
To se vidi iz ovog objasnjenja:
"Fig. 2. Basic 2 way 0° power splitter, simple "T".
The most basic form of a power splitter is a simple "T" connection, which has one input and two
outputs as shown in Fig. 2. If the "T" is mechanically symmetrical, a signal applied to the input
will be divided into two output signals, equal in amplitude and phase. The arrangement is simple
and it works, with limitations.
The two obvious limitations are poor isolation and impedance mismatch. First, let’s consider
isolation.
Suppose, for example, that two antennas were fed to a receiver input using a simple "T" as a
combiner. If one antenna appears as a short at its resonant frequency, it would load down the
other antenna and, in effect, wipe out the receiver input. However, a properly designed power
combiner would provide high isolation between inputs so that the antenna "short condition" at
one input would have little influence on the other input and would cause approximately a 3:1
VSWR mismatch at the output port, in this case, the receiver input."
u dokumentu:
www.minicircuits.com/app/AN10-006.pdf